Mocking Up New Risers, Tank, and Seat
After taking the stock tank off, I disassembled the stock riser setup and mocked up the short risers. I like them a lot and will stick with them as opposed to the slightly taller pullback ones I also bought.
I put the tank and seat on and I'm really happy with the results. The front of the tank is not currently attached and sitting a little high but I want to make a bracket to have it sit slightly higher. It's at about 1 1/2" higher than the stock position and I want it another 1/2" higher. I like the look and it should hopefully allow enough room to perform a wire tuck too. I like that the top of the tank is taller than the risers. I'll need to get a few shots from the front - it looks great.
Here's one in color:
I put the tank and seat on and I'm really happy with the results. The front of the tank is not currently attached and sitting a little high but I want to make a bracket to have it sit slightly higher. It's at about 1 1/2" higher than the stock position and I want it another 1/2" higher. I like the look and it should hopefully allow enough room to perform a wire tuck too. I like that the top of the tank is taller than the risers. I'll need to get a few shots from the front - it looks great.
Here's one in color:
